|
Measuring Guide Tips
- Provide all dimensions in “Inches” using 1/2” increments. Measure w/steel tape
- Customer is responsible for all measurements, special fitting situations, given or omitted. No cover returns
If your cover fits correctly, transfer measurements to the Order Form. Otherwise make adjustments to current cover measurements.
.
Be sure to consider an adequate length and width to cover the acrylic part of the tub, railings, etc.. Suggestion: It’s generally best to be slightly larger than the acrylic, than to have a perfect fit.

A B C D
Check one: ___My Cover Measurements Fit the Acrylic Plastic ___My Cover Measurements Fit the Spa Cabinet
How the Cover Folds: Indicate the length of the fold/hinge as "A" on the Order Form. This can be important in relation to control panels and how the cover comes off the tub.
Skirt Length: - Measure from the bottom of the cover to the bottom of the flap/skirt. If it must cover a wood edge or cover the shell, adjust accordingly. It’s best if the skirt hangs straight down.

Rounded/Radius (r) Corners
Measure from the beginning of the curve to the intersection of the other side. TIP: A carpenters square works well, or place a piece of cardboard over corner, mark & measure.

Cut Corners - See diagrams on Order Sheet.
Special Situations:
Narrow Plastic Lip: If the flat surface the cover sits on is less than 3 in.. Note, and ask for assistance.
Control Panels Protruding Above Flat, Plastic Surface / Control Panels Requiring Covers. Note, and call for assistance.
CoverLifts/Removers with lift bars over 1 in. require modications to fold. Maximum bar diamter is 1.25". Ask for assistance.
Note: Customer is responsible for all measurements, special fitting situations, given or omitted. Only written documents are valid.
Spa Covers are custom made. No cover returns.
Your EdenPure and Suntwin Portable Infrared Quartz Heater Dealer for Minnesota and Wisconsin |